Product ID:LASER TYPE TONER, SX
MSDS Date:09/15/1993
FSC:6850
NIIN:00N054597
MSDS Number: BVWSV

OASIS IMAGING PRODUCTS INC

20 HAMPSHIRE DR
HUDSON, NH 03051
US

Emergency Phone: 603-880-3991

Info Phone: 603-880-3991

Cage: XASXS

OASIS IMAGING PRODUCTS INC

HUNDSON, NH 03051 US

Telephone: 800-322-6092

Cage: XASXS

CARBON BLACK

CAS: 1333-86-4

RTECS: FF5800000

Fraction By Weight: <1%

OSHA PEL 3.5 MG/M3

ACGIH TLV: 3.5 MG/M3

IRON OXIDE

CAS: 1317-61-9

Fraction By Weight: 25-45%

OSHA PEL 10 MG/M3

ACGIH TLV: 5 MG/M3

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:MINIMAL RESP TRACT IRRIT MAY OCCUR AS
W/EXPOS TO LG AMTS OF ANY NON-TOXIC DUST. IN A CHRONIC INHAL STUDY
IN RATS USING SPEC TONER, THERE WERE NO LUNG CHANGES AT ALL IN
LOWEST LEVEL (1 MG/M3), MOST REL EVANT LEVEL TO POTENTIAL HUMAN
EXPOS. VERY SLIGHT DEGREE OF FIBROSIS WAS NOTED IN 25% OF ANIMALS
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:AT MIDDLE EXPOS LEVEL (4 MG/M3) WHILE
SLIGHT DEGREE OF FIBROSIS WAS OBSERVED AT HIGHEST EXPOS LEVEL (16
MG/M3) IN ALL ANIMALS. THESE FINDINGS ARE ATTRIBUTED TO "LUNG
OVERLOADING", GENERIC RES PONSE TO EXCESS AMTS OF ANY DUST RETAINED
IN LUNGS FOR PRLNGD INTERVAL. SPEC TEST TONER WAS TEN TIMES MORE
(SUPP DATA)
Medical Cond Aggravated by Exposure:NONE WHEN USED AS INTENDED IN THE
PRINTING EQUIPMENT FOR WHICH IT IS DESIGNED.

First Aid:INHAL:REMOVE FROM EXPOSURE. SKIN:WASH WITH SOAP AND WATER.
INGEST:DILUTE STOMACH CONTENTS WITH SEVERAL GLASSES OF WATER.
EYES:FLUSH WITH COPIOUS AMOUNTS OF WATER FOR AT LEAST 15 MINUTES .

Extinguishing Media:FOAM, DRY CHEMICAL, CO*2, WATER SPRAY OR MIST.
Fire Fighting Procedures:NIOSH/MSHA APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT . AVOID INHALATION OF SMOKE.
Unusual Fire/Explosion Hazard:MATERIAL IS COMBUSTIBLE. WHEN DISPERSED
IN AIR IT CAN FORM EXPLOSIVE MIXTURE.

Spill Release Procedures:LOOSE TONER CAN BE REMOVED USING A VACCUM
CLEANER. MAY BE SWEPT UP (AVOID DUST INHALATION. USE APPROPRIATE
DUST MASK IF NECESSARY)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN COOL, DRY, WELL VENTILATED
AREA. AVOID PROLONGED INHALATION OF EXCESSIVE DUST.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN .
Ventilation:NONE SPECIFIED BY MANUFACTURER.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EFTS OF OVEREXP:RESPIRABLE THAN COMMERCIALLY AVAILABLE TONER TO COMPLY
WITH EPA TESTING PROTOCOL.

HCC:N1
Melt/Freeze Pt:M.P/F.P Text:>212F,>100C
Spec Gravity:1.5-1.7(H*2O=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:FINE BLACK POWDER MILD RESINOUS ODOR.

Stability Indicator/Materials to Avoid:YES
STRONG OXIDANTS
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:PRODUCTS OF COMBUSTION CAN BE TOXIC
DEPENDING ON CONDITIONS. AVOID BREATHING SMOKE.

Waste Disposal Methods:DO NOT INCINERATE. INSURE CONFORMITY WITH
FEDERAL, STATE AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.